Geodesic Lines

The simulation of curved surface and generation of geodesic lines in cutting pattern for membrane structures

膜结构裁剪分析中曲面的模拟与短程线的生成

The simulation of curved surface and the generation of geodesic lines in the cutting pattern for membrane structures are discussed in the paper , it is two important problems in the cutting pattern .

对膜结构裁剪分析中的两个重要问题&膜结构曲面的模拟及短程线的生成方法进行了讨论。

Study on Several Kinds for Geodesic Lines of Elliptic Cylinder to Solve the Method

椭圆柱面上测地线的几种求解方法研究

Differential Equations and Differential Relationships of Geodesic Lines in New Form of Geodetic Coordinate System

新型大地坐标系中大地线的微分方程和微分式

Research of algorithm of geodesic lines involved in track programming of tape - laying

LayingFishermen自动铺带轨迹规划中测地线算法研究

This paper respectively discusses moving regularity of the filament control based on geodesic lines with above methods .

本文分别讨论在上述方法中测地线缠绕时丝嘴运动规律。

Based on this method , the dynamic relaxation method is used to determine the geodesic lines between two points on the curved surface .

以这一方法为基础，本文将动力松驰法应用于曲面上两点间短程线的计算中。

The necessary condition of external oscillations is the existence of closed geodesic lines on the surface of scatterers .

外部振荡存在的必要条件是散射体表面有闭合测地线。

In the cutting-pattern design , the geodesic lines are taken as cutting pattern line from which pattern shapes of air-supported membrane structure are gained .

以测地线为裁剪线进行裁剪设计，得到充气膜结构的施工下料尺寸。

The paper applies a value algorithm calculating geodesic lines between two points , aiming at the geodesic lines referred to the " nature paths " involved in track programming of fiber placement .

本文针对复合材料自动铺放轨迹规划中自然路径求解中的测地线问题给出了求解两点之间的测地线的数值计算方法。

The opening chapter gives a general overview of history of the development of the NURBS surface , awaken to the necessity of compute on geodesic and curvature lines of surface .

第一章综述了NURBS曲面的发展历程，由此引申出测地线和曲率线计算的必要性。